43026 Debris Removal DEB: Timeout: the pressure sensor output failed to stabilize Japanese_Newspaper_OEM_Engine Lotem_Quantum Magnus_400 Magnus_800 Magnus_VLF Thermoflex Trendsetter_400/800 Trendsetter_NEWS Trendsetter_Series_4 The output of one of the pressure sensors did not stabilize within the allowed time period. A device error has occurred: You may be able to continue by pressing the "resume" button onscreen (if present) or by resetting the device and workstation. For support under your service contract, contact the Creo Response Center at 1-(800) 472-2727 or online at http:\\eCentral.creo.com (or your local service representative) To speed troubleshooting, please make a note of error numbers, the media type/size and any information about the workflow or job that might be relevant. This error is reported. Cause 1: With the blower off the system is checking the pressure sensor(s) to see if they are stable. The system thinks that the pressure is fluctuating, and can't determine a stable reading to set the offset. Solution: Unplug the sensing line(s) to the offending sensor and reset the output device. If the error is still present then the sensor is defective and must be replaced. If the error goes away then the pressure really is unstable and the cause must be determined. If the nozzle sensor is unstable, try cleaning the nozzle (see UDRC Techplanet site for detailed instructions): HYPERLINK "http://techplanet.creo.com/output/heads/debris_removal/nav/proced.htm" http://techplanet.creo.com/output/heads/debris_removal/nav/proced.htm Reboot device and try again. Replace the appropriate sensor. 07-Jul-2001 ..\..\ShowAllErrors.htmFirmware 1 Error Index ..\..\ShowAllCommands.htmFirmware 1 Command Index ..\..\ShowAllParameters.htmFirmware 1 Parameter Index Updated: Thu Jul 17 07:23:36 2008 PST